COMICA CVM-WM100 WIRELESS LAVALIER MICROPHONE KIT
-18076-p.png?v=7ed2d6d2-22ed-4dee-8f47-551b4e434c16)
-18076-p.png?v=7ed2d6d2-22ed-4dee-8f47-551b4e434c16)
-18076-p.png?v=7ed2d6d2-22ed-4dee-8f47-551b4e434c16)
Model: CVM-WM100
- 100m maximum transmission distance
- 48 channels to choose from between 520-534.1MHz
- Less than .5% audio distortion
- Receiver and transmitter run on 2 AA batteries (not included)
- 3.5mm input/output ports with 3-pin XLR adapter included
- Mounts with included belt clips or via 1/4-20 mounting points on TX/RX bodies
- LCD screen includes signal strength and battery life indicators
The CVM-WM100 is a wireless lavalier microphone kit from CoMica. This kit contains one transmitter,
one receiver, one lavalier microphone with a 3.5mm connector, a soft case, and accessories like a
wind muff, 3.5mm-XLR adapter, and cold shoe mounts for the transmitter and receiver.
To use this kit, install two AA batteries in both the transmitter and receiver, then turn them on. Select one
of 48 available channels, and monitor for signal interference. If there is a lot of interference on one channel,
scan through others until you find a clean, noise-free channel to use. Both the transmitter and receiver can be
worn on the belt, mounted to the included cold shoe mounts, or attached to an accessory arm via the 1/4-20
mounting point on each unit.
When a solid signal is established, connect the lavalier mic and, if you desire, a secondary sound input device
to the transmitter. Plug the receiver into the camera, recorder, or speaker of your choice (for speakers, make
sure they have sufficient amplification to adequately handle the signal). Test the levels by taking test-audio,
and get to recording! When recording is finished, the entire kit can be placed into the included soft carrying
case for storage and transport.
Shipping Weight (lbs): 5.5
Shipping Dimensions (in): 14.5 x 10.25 x 3.5
LA CAJA INCLUYE:
1x 3.5mm Male-to-Male Output Cable (TRRS)
1x 3.5mm Male-to-Male Output Cable (TRS)
1x 3.5mm To XLR Male-to-Male Output Cable
1x Dual-Group Receiver
1x Hard Storage/Transport Case
2x Lavalier Microphones W/ 3.5mm Connectors
2x Transmitters
2x USB-to-USB Micro Charge Cables
2x Wind Muffs
3x Camera Cold Shoe Mounts
3x Removable Belt Clips
Quick Start Guide: CVM-WM100 Downloadable PDF
Antenna Type: Short Wave
Audio Distortion: < 0.5%
Battery Operation Time: ~10 hrs. (standby)
Battery Type: 2x AA Batteries per Receiver/Transmitter (not included)
Capacity mAh: 3.7V 2000mAh per unit
Frequency Bands: Group A:520~548.5MHz Group B: 550~578.5MHz
Inputs: 3.5mm
Outputs: 3.5mm
Receiver Sensitivity: -95dBm
Sound Delay: < 20ms
Stray Radiation: <-60dBc
Transmission Power: 10dBm/15dBm
UPC Code: 6971120980333
